Delivering Sustainable Water

Contact us

Design & Quote

Commercial Quotation Assessment

Please complete the form below and press the send button, and a member of our saeles team will be intouch

Customer details

Your Ref:

Contact Name:

Company:

Address:

Postcode:

Tel (including area code):

Email address:

Region:

Project name:

Location:

Type of project: (school, office, industrial, domestic, etc)

New build:

Retrofit:

What level of quotation and specification do you require?

We can provide either a ‘budget’ or ‘detailed’ specification and quotation.

A. Budget Specification and Quotation

This is a basic quotation and specification based on some assumptions. If you require a more detailed quote please complete both this Section A and Section B.

Reason for requirement:

To satisfy requirements to gain BREEAM accreditation:

To reduce surface water run-off from site:

To maximise water cost saving potential for the client:

To maximise the reduction of environmental impact for the project:

Designed to BS 8515 Standards:

Other:

The Building:

What is the total plan area of the building's roof? (m²):

Which roof drainage method will be employed?

gravity:

siphonic:

If siphonic drainage is used, what is the calculated drainage flow? (ltrs / sec):

Is the roof surface...

hard:

green / sedum:

What is the roof type?

pitched:

flat:

Rainwater use:

Will the rainwater be used for...

toilet flushing:

commercial process:

laundry:

irrigation:

other:

What will be the maximum number of residents, staff, pupils, etc, on-site?

Male:

Female:

What will be the annual consumption for irrigation, process, etc? (m³)

How many toilets will be served?

WC single flush volume

4.5 litres:

6.0 litres:

How many urinal ranges?

What is the estimated daily volume of water used for non-potable applications? (m3)

B. Detailed Specification and Quotation

This is a comprehensive quotation and specification based on specific data.
Please also complete Section A.

The rainwater holding tank:

Will the collection tank be...

Underground:

basement mounted:

surface mounted:

Will the tank be installed in...

soft landscaped area:

trafficked area:

Civils details:

Invert level of inlet pipe at the tank location (m):

Cover level at tank location (m):

Invert level of main storm sewer pipe to be connected to (m):

Area available for tank installation (m2):

The plumbing system:

Will the rainwater be delivered...

direct to the appliances:

to a high level header tank:

to a break tank / booster set:

What pressure and flow is required in the system?

bar:

ltrs/sec:

What is the route distance from the holding tank to our control panel? (m):

What is the height from ground level to the highest part of the plumbing system? (m):

What is the distance from the tank to the appliances / header tank? (m):

What diameter of pipe will be used to carry the rainwater? (mm):

Is a standby pump system required?

Yes:

No:

Does the rainwater require ultra violet disinfection?

Yes:

No:

Is there a size specification available for the header / break tank? (ltrs):

What pressure and flow is required from the booster set, if used?

bar:

ltrs/sec

Reasons for potential purchase

SUR1:

C. Further Information

If not you, who is the consultant responsible for the M&E Design?

Is there a budget cost already allocated? If so, what is this figure? (£/€)

Please provide any further information, in the space below, that you think we may find useful to allow a fully detailed specification and quotation to be prepared.

Security Question

For security purposes, type the word that you see in the image into the box below it. You can press the speaker icon to listen to the code if you need to.

Try a different word

Case Studies

DEFRA Offices, Alnwick, Northumberland

Lion House is an ultra low-emissions office building, designed and built for the Department of Environment, Food and Rural Affairs (Defra), in Alnwick, Northumberland.